I see what you did there, Gleek.
FroBozz_Inc wrote:FWIW, we've been using CAT5 for T1, SDSL, Ethernet, and phone lines here at work for YEARS without an issue.
http://newsgroups.derkeiler.com/Archive ... 00053.html
That guy says it's fine. As do others I've found. I have a call into US Signal for their advice.
FroBozz_Inc wrote:I was wondering if anyone has experience personally doing this - thanks. I think it's about 75-100 feet btwn smartjack and routers on one end, and only about 30-50 feet on the other end.
Ryu Connor wrote:My point still stands as well.
Taking a single CAT cable and splitting the pins in the manner suggested increases the likelyhood of head end attenuation and may compromise the EMI and crosstalk protection along the length of the cable as well.
The proper way to terminate a T1 beyond the Dmark is using T-Span Cable. It’s what we use when quoting the extending of a Dmark ($3.60 per foot)
Some use Cat5
Others use Cat3
Bottom line is it “Should” work, but in this business no hard and fast rules exist.
just brew it! wrote:You'd really think that a twisted pair cable designed to carry full-duplex 1000 Mbit/sec traffic would be able to handle a measly 3 Mbit/sec!
notfred wrote:http://www.inetdaemon.com/tutorials/telecom/t-carrier/T1/ suggests +12V or -12V and 0V but I thought it was more than that. I did a training course on a Siemens SMX 2100 about 12 years ago and I remember that the real telco guys were concerned they might get shocked by all the bare terminals labelled T1 until the instructor pointed out that they were not real T1s but at a lower voltage. The instructor also said the 1.5Mb/s of a T1 was based on the distance between the telco manhole covers in New York - they thought New York would use the most T1s and they could throw a repeater down each telco manhole. Given the tech at the time they ended up with 1.5Mb/s as what was a safe signal to transmit that distance.
Users browsing this forum: Bing [Bot] and 1 guest