No, but beggars can find a can of black spray paint. I share your annoyance at the logo (and the spelling -- if the logo was just a little abstract symbol it wouldn't be a big deal).Bauxite wrote:Still has annoying logos that ruin a clean look (even on their own cases) but beggars can't be choosers.
Bauxite wrote:USB3 ports to drive bay or pci bracket via proper header cable:
http://www.newegg.com/Product/Product.a ... 6811996037
thegleek wrote:yeah i'm in the same boat... the cooler master case came with that same usb 3.0 panel, alas the mobo i got (ASUS P8P67 LE rev3) indicates that it has double usb 3.0 access, yet there is no place on the mobo that allows the cable from that panel to plug into... I did notice a place on the mobo that looks like the same pinout, but nothing was soldered to it. Perhaps it exists only in the higher end PRO versions of this mobo?
LoneWolf15 wrote:I can only say this is what the header/cable looks like (courtesy of OCWorkbench). Looking at NewEgg's pictures of your board, I don't see the connector there, just some rear USB 3.0 ports. Perhaps the Deluxe and Pro versions do. http://www.techpowerup.com/img/10-07-15/63b.jpg
LoneWolf15 wrote:At any rate, that would be a cast-iron !#$%* to solder, as it's a surface mount component. The best you could probably do would be to solder ten wire leads off the board, then solder the connector to that. -which would be ugly.
Users browsing this forum: No registered users and 4 guests