maxxcool wrote:^^ What Brew says....
Also, make sure your motherboard has the Sata controller set to "native" or "sata mode" ... basicly make sure it does not say "compatibility mode", "ide mode", "legacy mode" where sata NCQ is turned off... having NQC off will have a impact as well.
MadManOriginal wrote:To further elaborate on this, SSDs (and really all hard drives these days) should be used in AHCI mode, or RAID mode if you're using RAID.
just brew it! wrote:Did a little more digging.
The Marvell 9128 chip used to provide the 6Gbps ports on that motherboard is a notoriously poor performer. Firstly, it interfaces to the northbridge via a single-lane PCIe 2.0 connection so it's hobbled from the get-go. Secondly, it's just plain s-l-o-w (and doesn't even come close to saturating that single PCIe lane).
As counter-intuitive as it seems, you actually might get better performance by using the SATA 3Gbps ports!
If you want to utilize the full potential of your SSD, it looks like you need to get a decent SATA 6Gbps controller. This is going to either mean a new motherboard, or a decent PCIe x4 controller installed in your second PCIe x16 slot (assuming you're not using dual video cards).
And FWIW a decent PCIe x4 controller will probably cost you about the same as a new motherboard...
Flying Fox wrote:It is actually a reason why I was able to justify the purchase of the Crucial M4 during Black Friday. Since I refuse the Marvell controller on my motherboard and will stick with SATA II.
Users browsing this forum: Bing [Bot] and 1 guest