There is a TR article that talks about the 4 numbers and latency (under misc category I think). I think you have the numbers correct IIRC. As for the voltage issue, this usually means the BIOS will default to 1.8V and will at least boot into the BIOS for you to change it. It should probably not run stable at 1.8V. I would say change that to 2.1V first and then memtest it. If you feel adventurous you can try lowering it 0.1V at a time and retest.Fragnificent wrote:I have a Shuttle SX38P2 with an X38, and 4x1 GB of Corsair XMS PC6400. I believe it is supposed to be set to "4-4-4-12" but what does each number refer to? The four numbers I know about are tRcd, tRp, tRAS, and tCAS. I'm assuming that 4-4-4-12 means CAS4, tRcd=4, tRp=4, and tRAS is 12. Is this correct? Also, ram is listed as 2.1v but the x38 defaults it to 1.8v. Should I manually set this? Yes I know there are like 100 threads about this already but none of them confirm this information for me to any degree. Help!?!?!
Users browsing this forum: No registered users and 3 guests