I have an HP laptop.
My wireless conn does not connect. I have tried many suggestions, there may be to many things added at this point. Here is the codes that I have been asked for in the past. Any help will be greatly appreciated.
iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11b/g ESSID:off/any Nickname:"Broadcom 4318"
Mode:Managed Frequency=2.472 GHz Access Point: Invalid
Bit Rate=1 Mb/s Tx-Power=18 dBm
RTS thr:off Fragment thr:off
Link Quality=0/100 Signal level=-256 dBm Noise level=-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sudo lshw -C network
*-network:0
description: Wireless interface
product: BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller
vendor: Broadcom Corporation
physical id: 2
bus info: pci@0000:03:02.0
logical name: eth1
version: 02
serial: 00:14:a5:23:13:4b
width: 32 bits
clock: 33MHz
capabilities: bus_master ethernet physical wireless
configuration: broadcast=yes driver=bcm43xx driverversion=2.6.22-15-generic latency=64 link=no module=bcm43xx multicast=yes wireless=IEEE 802.11b/g
*-network:1
description: Ethernet interface
product: RTL-8139/8139C/8139C+
vendor: Realtek Semiconductor Co., Ltd.
physical id: 6
bus info: pci@0000:03:06.0
logical name: eth0
version: 10
serial: 00:0f:b0:79:3c:a0
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=8139too driverversion=0.9.28 duplex=full ip=192.168.1.3 latency=128 link=yes maxlatency=64 mingnt=32 module=8139too multicast=yes port=MII speed=100MB/s
lspci
00:00.0 Host bridge: ATI Technologies Inc RS480 Host Bridge
00:01.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:04.0 PCI bridge: ATI Technologies Inc RS480 PCI Bridge
00:13.0 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller
00:13.1 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller
00:13.2 USB Controller: ATI Technologies Inc IXP SB400 USB2 Host Controller
00:14.0 SMBus: ATI Technologies Inc IXP SB400 SMBus Controller (rev 10)
00:14.1 IDE interface: ATI Technologies Inc Standard Dual Channel PCI IDE Controller
00:14.3 ISA bridge: ATI Technologies Inc IXP SB400 PCI-ISA Bridge
00:14.4 PCI bridge: ATI Technologies Inc IXP SB400 PCI-PCI Bridge
00:14.5 Multimedia audio controller: ATI Technologies Inc IXP SB400 AC'97 Audio Controller (rev 01)
00:14.6 Modem: ATI Technologies Inc SB400 AC'97 Modem Controller (rev 01)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
01:05.0 VGA compatible controller: ATI Technologies Inc Radeon XPRESS 200M 5955 (PCIE)
03:00.0 FireWire (IEEE 1394): Texas Instruments TSB43AB22/A IEEE-1394a-2000 Controller (PHY/Link)
03:02.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
03:04.0 CardBus bridge: Texas Instruments PCIxx21/x515 Cardbus Controller
03:04.3 Mass storage controller: Texas Instruments PCIxx21 Integrated FlashMedia Controller
03:04.4 Generic system peripheral [0805]: Texas Instruments PCI6411/6421/6611/6621/7411/7421/7611/7621 Secure Digital Controller
03:06.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
lsusb
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 005: ID 045e:00b9 Microsoft Corp. Wireless Optical Mouse 3.0
Bus 001 Device 001: ID 0000:0000
thanks in advance for your help
