Page 1 of 1

Ubiquiti - Static route from a guest network to a printer

Posted: Sat May 11, 2019 2:26 pm
by Fonbu
Using a ubituiti networks AC access point.

Is it possible to add a static route from a guest wifi network to a networked printer on another wifi network?

I couldnt figure this out.All the wifi networks are vlans for sure, and use the same ip address ranges. Like any guest network it cannot see the other wifi networks.

The wifi networks all use the same ip address range. But the vlans seperate them. the access points are connected to a cisco router.

I could check the cisco router, but it cant even see all the wifi vlans.

Any information, someone could provide would help!

Re: Ubiquiti - Static route from a guest network to a printer

Posted: Sat May 11, 2019 7:52 pm
by Usacomp2k3
Pretty sure you would configure that on the router. I don’t have experience doing it through, sorry.

Re: Ubiquiti - Static route from a guest network to a printer

Posted: Sun May 12, 2019 12:48 pm
by notfred
You are going to have to give us more detail on your setup. The routing would happen on the router which would need access to all the VLANs, as Usacomp2k3 says.