https://store.level1techs.com/products/ ... itor-model
Unfortunately it only supports up to USB 3.1 Gen 1
Full DisplayPort switching capabilities:
Up to 3840x2160@60hz
Lower resolutions + Higher framerates possible e.g. 144hz @ 1440p work just fine because of full DP 1.2a compatibility.
Intelligent EDID Engine
HDCP Passthrough Supported (maintains HDCP signal integrity)
Intelligent USB HID passthrough (includes work-arounds for known problematic devices)
4x 3.5mm Audio
4x DisplayPort 1.2
4x USB 3 (5gps)
1x Displayport 1.2a connection
3x USB 2.0 Ports
1x USB 3 (5gbps) port
1x analog 3.5mm audio
1-2-3-4 Pushbuttons for switching Inputs
1x USB 2.0 HID port
2x USB 3.0 (5gbps) ports (up to 1A current)
Keyboard commands supported:
Double-tap numlock to do a soft-reset on the USB hub (some USB peripherals do not like to be connected to a KVM!)
Double-tap scroll lock followed by 1-4 to switch between inputs without using the buttons on the front of the KVM. Total keyboard control! That means you could mount the KVM behind the monitor, inside the desk, etc and still be able to switch inputs.
The built-in USB hub means that you only need a single USB3 connection to each PC.
Life is a box of chocolates.