/// THREAD HIJACK ///
So I've used Clonezilla to take a disk image from an SSD. Our image is small enough to fit on a 120GB SSD (111GB in Windows) because we have a mix of potential destination drives. I think the source drive this image was taken from was an plain-jane 120GB Samsung 840. It's worked on 120GB Sandforce and 840EVO drives, also 128GB Sandisk and Toshiba drives.
With the new MX100 drives (128GB) Windows boots but bluescreens with an 0x0000001E error, even in safe mode. The SSD is fine because I can build windows from scratch on it no problem but something about this new MX100 makes it incompatible with the image.
Any suggestions? I don't understand the first thing about the inner workings of Clonezilla really, but it's always worked before and the most complicated option I've ever had to use is -ICDS to put the image on a slightly smaller drive (if it was taken from a 128GB disk and is going onto a 120GB disk).
This is my signature. There are many like it, but this one is mine. However, my signature is neither my best friend, nor is it my life. I also have no desire to master it and my worth is not signature-dependent.